Emc Installation Conditions; Sgdv-05 (Analog Pulse Model) - YASKAWA SGLGW User Manual

2.5

EMC Installation Conditions

This section describes the recommended installation conditions that satisfy EMC
guidelines for each model of the SGDV SERVOPACK. The conditions required for
the standard type (base-mounted) of SERVOPACK are described. Refer to this sec-
tion for other SERVOPACK models such as the rack-mounted types as well.
This section describes the EMC installation conditions satisfied in test conditions
prepared by Yaskawa. The actual EMC level may differ depending on the actual sys-
tem's configuration, wiring, and other conditions. However, because this product is
built-in, check that the following conditions are still met after being installed in the
user's product.
The applicable standards are EN55011/A2 group 1 class A, EN61800-3, and
EN61000-6-2.
2.5.1
SGDV-05 (Analog Pulse Model)
 Single-phase 100 V, SGDV-F05A ( = R70, R90, 2R1,
2R8)
Power supply:
Single-phase
100 VAC
PE
Symbol





www.dadehpardazan.ir 88594014-15
One turn
Noise
filter
5
Surge
absorber
Two turn
Two turn
Cable Name
I/O signal cable
Cable for safety unit
Linear servomotor main circuit cable
Linear scale connection cables
Main circuit cable

2.5 EMC Installation Conditions

Shield box
SERVOPACK
U, V, W
L1, L2
One turn
L1C, L2C
CN2
CN1 CN8
Core Core
Two turn
Clamp
1 2
Host Safety unit
controller
Specification
Shield cable
Shield cable
Shield cable
Shield cable
Shield cable
Brake
Linear
3
servomotor
Linear
scale
4
PE
2-37
2