YASKAWA SGLGW User Manual page 35

2 Installation
2.2.2 SGLFW and SGLFM Linear Servomotors (F-type Iron Core)
2.
3.
(3) Magnetic Attraction
The linear servomotor is constructed of an opposing moving coil and magnetic way.
Therefore, the moving coil is subjected to magnetic attraction as shown in the follow-
ing table (calculated value). Consider the magnetic attraction when designing the sys-
tem.
2-12
Insert a thin nonmagnetic (preferably resin) sheet (approximately 0.5-
mm thick) in the air gap between the moving coil and magnetic way.
Then, and move the moving coil toward the magnetic way.
Always be aware of the strong magnetism of the magnetic way and
keep fingers and tools at a safe distance, especially when the moving
coil is near the magnetic way. The moving coil will be strongly
attracted to the magnetic way. When the specified dimensions of the
air gaps between the moving coil and the magnetic way are secured,
it is not necessary to insert nonmagnetic sheets into the air gaps. (see
the table of dimensions in step 1.)
Move the moving coil back and forth several times over the magnetic
way from end to end, making sure that the moving coil is not touching
the magnetic way and that no foreign objects (such as magnetic
particles) are present. Use a nonmagnetic (brass or stainless steel) gap
gauge to check that the air gap between the moving coil and the
magnetic way is even.
www.dadehpardazan.ir 88594014-15
Slowly move the
moving coil.
Nonmagnetic
sheet