YASKAWA SGLGW User Manual page 95

3 Wiring and Connection
3.2.2 Connecting to SGDV-15 SERVOPACK (M-II Model)
 Using a Single-phase, 200-V Power Supply
The -V Series SERVOPACK for a 200-V power supply input has input specifica-
tions for a three-phase power supply, but some models can also be used with a single-
phase 200-V power supply. For details, refer to
Maintenance Linear Motor/MECHATROLINK-II Communications Reference (SIEP
S800000 48).
Power supply
Single-phase 200 VAC
Molded-case
circuit breaker
(MCCB)
Protects the power supply
line by shutting the
circuit OFF when
overcurrent is
detected.
Noise filter
Used to eliminate
external noise from
the power line.
Regenerative
resistor*
Linear servomotor
main circuit cable
 Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.4 Con-
necting Regenerative Resistors.
3-10
R T
SGDV-
SERVOPACK
Magnetic
contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
www.dadehpardazan.ir 88594014-15

A15
Connection cable
for digital operator
Connection cable
for personal computer
I/O signal cable
Cable for connecting a
serial converter unit
Serial converter unit
Cable for connecting a
linear scale
Linear scale
(Not included)
-V Series User's Manual Design and
Connect to the
MECHATROLINK-II
Host controller
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specifically for the safety function.
Cable for connecting a
hall sensor
Linear servomotor
with core
Digital
operator
Personal
computer
Safety function
devices