Gvrp Fixed Registration Mode Configuration Example - HP 6600 Configuration Manual

[RouterA-GigabitEthernet3/0/1] gvrp
[RouterA-GigabitEthernet3/0/1] quit
# Create VLAN 2 (a static VLAN).
[RouterA] vlan 2
[RouterA-vlan2] quit
2. Configure Router B:
# Enable GVRP globally.
<RouterB> system-view
[RouterB] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[RouterB] interface GigabitEthernet 3/0/1
[RouterB-GigabitEthernet3/0/1] port link-type trunk
[RouterB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on trunk port GigabitEthernet 3/0/1.
[RouterB-GigabitEthernet3/0/1] gvrp
[RouterB-GigabitEthernet3/0/1] quit
# Create VLAN 3 (a static VLAN).
[RouterB] vlan 3
[RouterB-vlan3] quit
3. Verify the configuration:
Use the display gvrp local-vlan command to display the local VLAN information that GVRP
maintains on ports. For example:
# Display the local VLAN information that GVRP maintains on port GigabitEthernet 3/0/1 of
Router A.
[RouterA] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 2 on the
local router, and dynamic VLAN information about VLAN 3 on Router B are all registered through
GVRP.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 3/0/1 of
Router B.
[RouterB] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 3 on the
local router, and dynamic VLAN information about VLAN 2 on Router A are all registered through
GVRP.

GVRP fixed registration mode configuration example

Network requirements
As shown in
registration and deregistration of static VLAN information between the two routers.
Figure 47, enable GVRP and configure the fixed registration mode on ports to enable
138