Configuring One-To-Two Vlan Mapping; Configuration Prerequisites; Configuring An Uplink Policy - HP 6600 Configuration Manual

Configuring one-to-two VLAN mapping

Perform one-to-two VLAN mapping on the edge devices from which customer traffic enters SP networks,
on PE 1 and PE 4 in
insert an outer VLAN tag to each incoming packet.
Complete the following tasks to configure one-to-two VLAN mapping:
Task

Configuring an uplink policy

Configuring the customer-side port
Configuring the network-side port

Configuration prerequisites

Create VLANs, and plan CVLAN-to-SVLAN mappings.
Configuring an uplink policy
To configure an uplink policy to insert an SVLAN to VLAN tagged packets:
Step
1. Enter system view.
2. Configure a class for a
CVLAN.
3. Configure one behavior
for an SVLAN.
4. Create a QoS policy
and enter QoS policy
view.
Figure 65 for example. One-to-two VLAN mapping enables the edge devices to
Remarks
Configures an uplink policy for the customer-side port (required).
Configures VLAN and other settings required for one-to-two VLAN
mapping (required).
Configures VLAN and other settings required for one-to-two VLAN
mapping (required).
Command
system-view
a. Create a class and enter class view:
traffic classifier tcl-name [ operator
{ and | or } ]
b. Configure CVLAN match criteria:
if-match customer-vlan-id { vlan-list |
vlan-id1 to vlan-id2 }
c. Return to system view:
quit
a. Create a traffic behavior and enter
traffic behavior view:
traffic behavior behavior-name
b. Add a VLAN nest action to insert an
outer VLAN tag into incoming packets
from the CVLAN or CVLANs:
nest top-most vlan-id vlan-id
c. Return to system view:
quit
qos policy policy-name
190
Remarks
N/A
N/A
Repeat this step to configure
one behavior for each
SVLAN.
N/A