Assigning A Trunk Port To A Vlan - HP 6600 Configuration Manual

Step
2. Enter interface view or
port group view.
3. Configure the link type of
the ports as access.
4. Assign the access ports
to a VLAN.

Assigning a trunk port to a VLAN

A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view.
To assign a trunk port to one or multiple VLANs:
Step
1. Enter system view.
2. Enter interface view or
port group view.
Command
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregation
interface view:
interface
bridge-aggregation
interface-number
•
Enter port group view:
port-group manual
port-group-name
port link-type access
port access vlan vlan-id
Command
system-view
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregation
interface view:
interface
bridge-aggregation
interface-number
•
Enter port group view:
port-group manual
port-group-name
96
Remarks
Use one of the commands.
•
The configuration made in Layer 2
Ethernet interface view applies only to the
port.
•
The configuration made in port group
view applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
Optional.
By default, all ports are access ports.
Optional.
By default, all access ports belong to VLAN
1.
Remarks
N/A
Use one of the commands.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.