Layer 2 Aggregation Load Sharing Configuration Example - HP 6600 Configuration Manual

[RouterA-Bridge-Aggregation1] port trunk permit vlan 10 20
Please wait... Done.
Configuring GigabitEthernet4/0/1... Done.
Configuring GigabitEthernet4/0/2... Done.
Configuring GigabitEthernet4/0/3... Done.
[RouterA-Bridge-Aggregation1] quit
# Configure the device to use the source and destination MAC addresses of packets as the global
link-aggregation load-sharing criteria.
[RouterA] link-aggregation load-sharing mode source-mac destination-mac
2. Configure Router B in the same way Router A is configured. (Details not shown.)
3. Verify the configurations:
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
BAGG1
The output shows that link aggregation group 1 is a load-shared Layer 2 dynamic aggregation
group, and it contains three Selected ports.
# Display the global link-aggregation load-sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.

Layer 2 aggregation load sharing configuration example

Network requirements
Configure two Layer 2 static aggregation groups (1 and 2) on Router A and Router B (in
enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and
VLAN 20 at one end to communicate with VLAN 20 at the other end.
Configure the load sharing criterion for link aggregation group 1 as the source MAC addresses of
packets and the load sharing criterion for link aggregation group 2 as the destination MAC addresses
of packets to enable traffic to be load-shared across aggregation group member ports.
AGG Partner ID
Mode
D 0x8000, 000f-e2ff-0002
Select Unselect
Ports
3
31
Share
Ports Type
0 Shar
Figure 8), and