Layer 2 Static Aggregation Configuration Example - HP 6600 Configuration Manual

Layer 2 static aggregation configuration example

Network requirements
Configure a Layer 2 static aggregation group on Router A and Router B (in
at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one
end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
destination MAC addresses.
Figure 6 Network diagram
Configuration procedure
1. Configure Router A:
# Create VLAN 10, and assign port GigabitEthernet 4/0/4 to VLAN 10.
<RouterA> system-view
[RouterA] vlan 10
[RouterA-vlan10] port GigabitEthernet 4/0/4
[RouterA-vlan10] quit
# Create VLAN 20, and assign port GigabitEthernet 4/0/5 to VLAN 20.
[RouterA] vlan 20
[RouterA-vlan20] port GigabitEthernet 4/0/5
[RouterA-vlan20] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 1.
[RouterA] interface bridge-aggregation 1
[RouterA-Bridge-Aggregation1] quit
# Assign ports GigabitEthernet 4/0/1 through GigabitEthernet 4/0/3 to link aggregation group
1.
[RouterA] interface GigabitEthernet 4/0/1
[RouterA-GigabitEthernet4/0/1] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/1] quit
[RouterA] interface GigabitEthernet 4/0/2
[RouterA-GigabitEthernet4/0/2] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/2] quit
[RouterA] interface GigabitEthernet 4/0/3
28
Figure 6). Enable VLAN 10