Configuring A Layer 2 Dynamic Aggregation Group - HP 6600 Configuration Manual

Step
5. Assign the port an
aggregation priority.

Configuring a Layer 2 dynamic aggregation group

To guarantee a successful dynamic aggregation, make sure the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
To configure a Layer 2 dynamic aggregation group:
Step
1. Enter system view.
2. Set the system LACP priority.
3. Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
5. Exit to system view.
6. Assign a Layer 2 Ethernet
interface to the aggregation
group.
Command
link-aggregation port-priority
port-priority
Command
system-view
lacp system-priority system-priority
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
a. interface interface-type
interface-number
b. port link-aggregation
group number
20
Remarks
Optional.
By default, the aggregation priority
of a port is 32768.
When the number of ports eligible
for becoming Selected ports
exceeds the maximum number of
Selected ports allowed in a static
aggregation group, changing the
aggregation priority of a port
might affect the aggregation state
of the ports in the static
aggregation group.
Remarks
N/A
Optional.
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in a dynamic
aggregation group.
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
By default, an aggregation group
operates in static aggregation
mode.
N/A
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.