Displaying And Maintaining Super Vlan; Super Vlan Configuration Example - HP 6600 Configuration Manual

Step
4. Enable local proxy ARP.
5. Enable local proxy ND.

Displaying and maintaining super VLAN

Task
Display mapping between a super
VLAN and its sub-VLANs.

Super VLAN configuration example

Network requirements
As shown in
Create super VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
•
• Create sub-VLANs VLAN 2, VLAN 3, and VLAN 5.
Assign GigabitEthernet 4/0/1 and GigabitEthernet 4/0/2 to VLAN 2, GigabitEthernet 4/0/3
•
and GigabitEthernet 4/0/4 to VLAN 3, and GigabitEthernet 4/0/5 and GigabitEthernet 4/0/6
to VLAN 5.
The sub-VLANs are isolated at Layer 2 but connected at Layer 3.
•
Figure 39 Network diagram
Configuration procedure
# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
Figure 39:
Command
•
Enable local proxy ARP:
local-proxy-arp enable
•
Enable local proxy ND:
local-proxy-nd enable
Command
display supervlan [ supervlan-id ] [ | { begin |
exclude | include } regular-expression ]
116
Remarks
Use one of the commands.
By default, local proxy ARP and
local proxy ND are disabled.
For more information about local
proxy ARP and proxy ND
functions, see Layer 3—IP Services
Configuration Guide. For more
information about local-proxy-arp
enable and local-proxy-nd enable
commands, see Layer 3—IP
Services Command Reference.
Remarks
Available in any
view.