Protocol-Based Vlan Configuration Example - HP 6600 Configuration Manual

Step
4. Exit VLAN view.
5. Enter interface view or port
group view.
6. Configure the port link
type as hybrid.
7. Assign the hybrid port to
specified protocol-based
VLANs.
8. Assign the protocol
template you have created
to the hybrid port.

Protocol-based VLAN configuration example

Network requirements
In a lab environment as shown in
protocol for teaching purposes.
To avoid interference, isolate IPv4 traffic and IPv6 traffic at Layer 2.
Figure 37 Network diagram
Command
quit
•
Enter Ethernet interface
view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-list
{ tagged | untagged }
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Figure 37, most hosts run the IPv4 protocol, and the rest run the IPv6
107
Remarks
N/A
Use one of the commands.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port
group.
By default, all ports are access ports.
By default, a hybrid port is only in VLAN
1.
N/A