HP 6600 Configuration Manual page 39

Enable traffic to be load-shared across aggregation group member ports based on source and
destination MAC addresses.
Figure 7 Network diagram
Configuration procedure
1. Configure Router A:
# Create VLAN 10, and assign the port GigabitEthernet 4/0/4 to VLAN 10.
<RouterA> system-view
[RouterA] vlan 10
[RouterA-vlan10] port GigabitEthernet 4/0/4
[RouterA-vlan10] quit
# Create VLAN 20, and assign the port GigabitEthernet 4/0/5 to VLAN 20.
[RouterA] vlan 20
[RouterA-vlan20] port GigabitEthernet 4/0/5
[RouterA-vlan20] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link aggregation
mode as dynamic.
[RouterA] interface bridge-aggregation 1
[RouterA-Bridge-Aggregation1] link-aggregation mode dynamic
# Assign ports GigabitEthernet 4/0/1 through GigabitEthernet 4/0/3 to link aggregation group
1 one at a time.
[RouterA] interface GigabitEthernet 4/0/1
[RouterA-GigabitEthernet4/0/1] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/1] quit
[RouterA] interface GigabitEthernet 4/0/2
[RouterA-GigabitEthernet4/0/2] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/2] quit
[RouterA] interface GigabitEthernet 4/0/3
[RouterA-GigabitEthernet4/0/3] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/3] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as a trunk port and assign it to
VLANs 10 and 20.
[RouterA] interface bridge-aggregation 1
[RouterA-Bridge-Aggregation1] port link-type trunk
30