Configuring The Customer-Side Port; Configuring The Network-Side Port - HP 6600 Configuration Manual

Step
4. Create a QoS
policy and enter
QoS policy view.
5. Associate the class
with the behavior.

Configuring the customer-side port

Step
1. Enter system view.
2. Enter interface view.
3. Configure the link type of the
port.
4. Assign the port to all
CVLANs.
5. Apply the uplink policy
configured for the
customer-side port to
incoming traffic.
6. Apply the downlink policy
configured for the
customer-side port to outgoing
traffic.

Configuring the network-side port

Step
1. Enter system view.
Command
qos policy policy-name
classifier tcl-name behavior behavior-name
Command
system-view
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Ethernet port group view:
port-group manual
port-group-name
•
Configure the port as a trunk
port:
port link-type trunk
•
Configure the port as a hybrid
port:
port link-type hybrid
•
As a trunk port:
port trunk permit vlan { vlan-list
| all }
•
As a hybrid port:
port hybrid vlan vlan-list
tagged
qos apply policy policy-name
inbound
qos apply policy policy-name
outbound
Command
system-view
195
Remarks
N/A
Repeat this step to create other
class-behavior associations.
Remarks
N/A
N/A
Use one of the commands.
The default link type of an Ethernet
port is access.
Use one of the commands.
By default:
•
A trunk port is assigned to only
VLAN 1.
•
A hybrid port is an untagged
member of VLAN 1.
N/A
N/A
Remarks
N/A