Configuration Procedure - HP 6600 Configuration Manual

Figure 63 Network diagram

Configuration procedure

1. Configure DHCP relay agent Provider A:
# Enable DHCP service.
<ProviderA> system-view
[ProviderA] dhcp enable
# Create the DHCP server group.
[ProviderA] dhcp relay server-group 1 ip 10.2.1.1
# Create a Layer 3 Ethernet subinterface GigabitEthernet 4/0/1.100.
[ProviderA] interface GigabitEthernet 4/0/1.100
# Configure subinterface GigabitEthernet 4/0/1.100 to terminate packets whose Layer 2 VLAN
ID is 10 or 20.
[ProviderA-GigabitEthernet4/0/1.100] vlan-type dot1q vid 100 second-dot1q 10 20
# Enable subinterface GigabitEthernet 4/0/1.100 to transmit broadcasts and multicasts.
[ProviderA-GigabitEthernet4/0/1.100] vlan-termination broadcast enable
# Enable DHCP relay on GigabitEthernet 4/0/1.100, select a DHCP server group, and enable
address check on the DHCP relay agent.
[ProviderA-GigabitEthernet4/0/1.100] dhcp select relay
[ProviderA-GigabitEthernet4/0/1.100] dhcp relay server-select 1
[ProviderA-GigabitEthernet4/0/1.100] dhcp relay address-check enable
# Assign an IP address to GigabitEthernet 4/0/1.100.
[ProviderA-GigabitEthernet4/0/1.100] ip address 192.168.1.1 24
175