Configuration Example For Dot1Q Termination Supporting Pppoe Server; Network Requirements; Configuration Procedure - HP 6600 Configuration Manual

<Router> system-view
[Router] interface GigabitEthernet 4/0/1.10
[Router-GigabitEthernet4/0/1.10] ip address 1.1.1.11 255.255.255.0
# Enable Dot1q termination on GigabitEthernet 4/0/1.10, and configure the subinterface to
terminate VLAN-tagged packets whose Layer 1 VLAN ID is in the range of 11, 12, or 13.
[Router-GigabitEthernet4/0/1.10] vlan-type dot1q vid 11 to 13
[Router-GigabitEthernet4/0/1.10] quit
# Configure an IP address for GigabitEthernet4/0/2.
[Router] interface GigabitEthernet 4/0/2
[Router-GigabitEthernet4/0/2] ip address 1.1.2.11 255.255.255.0
Use the factory configuration of Layer 2 Switch B.
4.
5. Assign each device in the server group an IP address on the network segment 1.1.2.0/24, and
configure the gateway IP address as 1.1.2.11/24.
Configuration example for Dot1q termination
supporting PPPoE server

Network requirements

As shown in
VLAN 12, and VLAN 13, respectively.
Configure Dot1q termination, so that the hosts can dial up to access the Internet.
Figure 59 Network diagram

Configuration procedure

1. Configure VLANs and Dot1q termination:
For the configuration procedure, see
Figure 59, Host A, Host B, and Host C are connected to a switch, and belong to VLAN 1 1,
"Ambiguous Dot1q termination configuration
169
example."