Step
3.
Set the expected bandwidth
for the aggregate interface.
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of
aggregated member ports in the following ways:
When an aggregate interface is shut down, all Selected member ports become unselected and
•
their link state becomes down. Shutting down a Layer 3 aggregate subinterface does not affect any
aggregation group, because Layer 3 aggregate subinterfaces are not associated with any
aggregation groups.
When an aggregate interface is brought up, the aggregation state of member ports is recalculated
•
and their link state becomes up.
To shut down an aggregate interface:
Step
1.
Enter system view.
2.
Enter aggregate interface
view.
3.
Shut down the aggregate
interface or subinterface.
Restoring the default settings for an aggregate interface
Step
1.
Enter system view.
2.
Enter aggregate interface
view.
3.
Restore the default settings for
the aggregate interface or
subinterface.
Command
bandwidth bandwidth-value
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface route-aggregation
interface-number
shutdown
Command
system-view
•
Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface view:
interface route-aggregation
interface-number
default
25
Remarks
N/A
Remarks
N/A
Use either command.
By default, aggregate interfaces or
subinterfaces are up.
Remarks
N/A
Use either command.
N/A