Configuring Load-Sharing Criteria For Link Aggregation Groups; Configuring The Global Link-Aggregation Load Sharing Criteria; Configuring Load-Sharing Criteria For An Aggregation Group - HP 6600 Configuration Manual

Configuring load-sharing criteria for link
aggregation groups
You can determine how traffic is load-shared in a link aggregation group by configuring load-sharing
criteria. The criteria can be source MAC address, destination MAC address, source IP address, or
destination IP address carried in packets, or combination of source and destination MAC addresses or
of source and destination IP addresses. You can also configure the system to perform per-packet load
sharing.
You can configure global or group-specific load-sharing criteria. A link aggregation group preferentially
uses the group-specific load-sharing criteria. If no group-specific load-sharing criteria is available, the
group uses the global load-sharing criteria.

Configuring the global link-aggregation load sharing criteria

Step
1. Enter system view.
2. Configure the global
link-aggregation
load-sharing criteria.

Configuring load-sharing criteria for an aggregation group

Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Configure the load-sharing
criteria for the aggregation
group.
Command
system-view
link-aggregation
load-sharing mode
{ { destination-ip |
destination-mac |
source-ip | source-mac } *
| per-packet }
Command
system-view
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
link-aggregation load-sharing mode
{ { destination-ip | destination-mac |
source-ip | source-mac } * |
per-packet }
26
Remarks
N/A
The default settings are source and destination
MAC addresses for Layer 2 traffic and source
and destination IP addresses for Layer 3 traffic.
Global link-aggregation load sharing criteria
configuration applies to all aggregation groups.
Remarks
N/A
Use either command.
The default setting is the global
load-sharing criteria.
Layer 2 aggregate interfaces do
not support the per-packet
keyword.