Layer 2 Dynamic Aggregation Configuration Example - HP 6600 Configuration Manual

[RouterA-GigabitEthernet4/0/3] port link-aggregation group 1
[RouterA-GigabitEthernet4/0/3] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as a trunk port and assign it to
VLANs 10 and 20.
[RouterA] interface bridge-aggregation 1
[RouterA-Bridge-Aggregation1] port link-type trunk
[RouterA-Bridge-Aggregation1] port trunk permit vlan 10 20
Please wait... Done.
Configuring GigabitEthernet4/0/1... Done.
Configuring GigabitEthernet4/0/2... Done.
Configuring GigabitEthernet4/0/3... Done.
[RouterA-Bridge-Aggregation1] quit
# Configure Router A to use the source and destination MAC addresses of packets as the global
link-aggregation load-sharing criteria.
[RouterA] link-aggregation load-sharing mode source-mac destination-mac
2. Configure Router B in the same way Router A is configured. (Details not shown.)
3. Verify the configurations:
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
BAGG1
The output shows that link aggregation group 1 is a load-shared Layer 2 static aggregation group
and it contains three Selected ports.
# Display the global link-aggregation load-sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements
Configure a Layer 2 dynamic aggregation group on Router A and Router B (in
10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one
end to communicate with VLAN 20 at the other end.
AGG Partner ID
Mode
S none
Select Unselect
Ports
3
29
Share
Ports Type
0 Shar
Figure 7). Enable VLAN