HP 6600 Configuration Manual page 42

[RouterA-Bridge-Aggregation1] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 2, and configure the load sharing
criterion for the link aggregation group as the destination MAC addresses of packets.
[RouterA] interface bridge-aggregation 2
[RouterA-Bridge-Aggregation2] link-aggregation load-sharing mode destination-mac
[RouterA-Bridge-Aggregation2] quit
# Assign ports GigabitEthernet 4/0/3 and GigabitEthernet 4/0/4 to link aggregation group 2.
[RouterA] interface GigabitEthernet 4/0/3
[RouterA-GigabitEthernet4/0/3] port link-aggregation group 2
[RouterA-GigabitEthernet4/0/3] quit
[RouterA] interface GigabitEthernet 4/0/4
[RouterA-GigabitEthernet4/0/4] port link-aggregation group 2
[RouterA-GigabitEthernet4/0/4] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 2 as a trunk port and assign it to
VLAN 20.
[RouterA] interface bridge-aggregation 2
[RouterA-Bridge-Aggregation2] port link-type trunk
[RouterA-Bridge-Aggregation2] port trunk permit vlan 20
Please wait... Done.
Configuring GigabitEthernet4/0/3... Done.
Configuring GigabitEthernet4/0/4... Done.
[RouterA-Bridge-Aggregation2] quit
2. Configure Router B in the same way Router A is configured. (Details not shown.)
3. Verify the configurations:
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG
Interface Mode
-------------------------------------------------------------------------------
BAGG1 S
BAGG2 S
The output shows that link aggregation groups 1 and 2 are both load-sharing-capable Layer 2
static aggregation groups and each contains two Selected ports.
# Display all the group-specific load-sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode interface
Bridge-Aggregation1 Load-Sharing Mode:
source-mac address
Bridge-Aggregation2 Load-Sharing Mode:
Partner ID
none
none
33
Select Unselect Share
Ports Ports Type
2 0 Shar
2 0 Shar