Pvid Auto Assign Settings; Subnet Vlan - D-Link xstack DES-3810 series Reference Manual

®
xStack

PVID Auto Assign Settings

Users can enable or disable PVID Auto Assign Status. The default setting is enabled.
To view the following window, click L2 Features > VLAN > PVID Auto Assign Settings, as shown below:
Click the Apply button to accept the changes made.

Subnet VLAN

Subnet VLAN Settings
A subnet VLAN entry is an IP subnet-based VLAN classification rule. If an untagged or priority-tagged IP packet is
received on a port, its source IP address will be used to match the subnet VLAN entries. If the source IP is in the
subnet of an entry, the packet will be classified to the VLAN defined for this subnet.
On this page the user can configure the subnet VLAN parameters.
To view the following window, click L2 Features > VLAN > Subnet VLAN > Subnet VLAN Settings, as shown
below:
The fields that can be configured are described below:
Parameter
VLAN Name
VID
IPv4 Network Address
IPv6 Network Address
Click the Add button to add a new entry based on the information entered.
Click the Find button to locate a specific entry based on the information entered.
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 5-15 PVID Auto Assign Settings window
Figure 5-16 Subnet VLAN Settings window
Description
The user can enter a VLAN Name here.
The user can enter a VID value here.
The user can enter the IPv4 address used in here. Remember to include the subnet mask
using the / notation.
The user can enter the IPv6 address used in here. Remember to include the subnet mask
using the / notation.
85