Ospf - D-Link xstack DES-3810 series Reference Manual

®
xStack
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Edit button to re-configure the specific entry.
Click the Edit button to see the following window.
The fields that can be configured are described below:
Parameter
Network Address
IPv6 Address/Prefix
Length
Source IPv4 Address
Destination IPv4
Address
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made for each individual section.

OSPF

The Open Shortest Path First (OSPF) routing protocol uses a link-state algorithm to determine routes to network
destinations. A "link" is an interface on a router and the "state" is a description of that interface and its relationship to
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 6-16 IP Tunnel GRE Settings window
Description
Enter the IP tunnel interface name.
Figure 6-17 IP Tunnel GRE Settings (Edit) window
Description
Enter the IPv4 network address assigned to the GRE tunnel interface. IPv4 processing
will be enabled on the IPv4 tunnel interface when an IPv4 address is configured. This
IPv4 address is not connected with the tunnel source or destination IPv4 address.
Enter the IPv6 network address assigned to the GRE tunnel interface. IPv6 processing
will be enabled on the IPv6 tunnel interface when an IPv6 address is configured. This
IPv6 address is not connected with the tunnel source or destination IPv4 address.
Click the radio button and enter the source IPv4 address of the GRE tunnel interface. It is
used as the source address for packets in the tunnel.
Click the radio button and enter the destination IPv4 address of the GRE tunnel interface.
It is used as the destination address for packets in the tunnel.
173