D-Link xstack DES-3810 series Reference Manual page 398

Layer 3 managed ethernet switch
Hide thumbs Also See for xstack DES-3810 series:
Table of Contents

Advertisement

®
xStack
After clicking the Edit button, the following page will appear:
The fields that can be configured are described below:
Parameter
MEP State
CCM State
PDU Priority
Fault Alarm
Alarm Time (250-1000)
Alarm Reset Time (250-
1000)
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Edit AIS button to configure the AIS settings.
Click the Edit LCK button to configure the LCK settings.
After clicking the Edit AIS button, the following window will appear:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 11-8 CFM MEP Information – Edit window
Description
This is the MEP administrative state.
Enable - MEP is enabled.
Disable - MEP is disabled. This is the default value.
This is the CCM transmission state.
Enable - CCM transmission enabled.
Disable - CCM transmission disabled. This is the default value.
The 802.1p priority is set in the CCMs and the LTMs messages transmitted by the MEP.
The default value is 7.
This is the control types of the fault alarms sent by the MEP.
All - All types of fault alarms will be sent.
Mac Status - Only the fault alarms whose priority is equal to or higher than "Some Remote
MEP MAC Status Error" are sent.
Remote CCM - Only the fault alarms whose priority is equal to or higher than "Some
Remote MEP Down" are sent.
Errors CCM - Only the fault alarms whose priority is equal to or higher than "Error CCM
Received" are sent.
Xcon CCM - Only the fault alarms whose priority is equal to or higher than "Cross-connect
CCM Received" are sent.
None - No fault alarm is sent. This is the default value.
This is the time that a defect must exceed before the fault alarm can be sent. The unit is
in centiseconds, the range is 250-1000. The default value is 250.
This is the dormant duration time before a defect is triggered before the fault can be re-
alarmed. The unit is in centiseconds, the range is 250-1000. The default value is 1000
385

Advertisement

Table of Contents
loading

Table of Contents