Table of Contents
Advertisement
®
xStack
Action
Click the <<Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
After clicking the View button, the following page will appear:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Drop Packet – Drop the packet immediately.
Remark DSCP – Mark the packet with a specified DSCP. The packet is set to drop
for packets with a high precedence.
trTCM – Specify the "two-rate three-color mode."
CIR – Specify the Committed information Rate. The unit is Kbps. CIR should always
be equal or less than PIR.
PIR – Specify the Peak information Rate. The unit is Kbps. PIR should always be
equal to or greater than CIR.
CBS – Specify the Committed Burst Size. The unit is in kilobyte.
PBS – Specify the Peak Burst Size. The unit is in kilobyte.
srTCM – Specify the "single-rate three-color mode".
CIR – Specify the Committed Information Rate. The unit is in Kbps.
CBS – Specify the Committed Burst Size. The unit is in kilobyte.
EBS – Specify the Excess Burst Size. The unit is in kilobyte.
Conform – This field denotes the green packet flow. Green packet flows may have their
DSCP field rewritten to a value stated in this field. Users may also choose to count green
packets by using counter parameter.
Replace DSCP – Packets that are in the green flow may have their DSCP field
rewritten using this parameter and entering the DSCP value to replace.
Counter – Use this parameter to enable or disable the packet counter for the specified
ACL entry in the green flow.
Un-conform – This changes the DSCP of an un-conforming (yellow or red) packet.
Replace DSCP – Packets that are in the yellow and red flow may have their DSCP
field rewritten using this parameter and entering the DSCP value to replace.
Exceed – This field denotes the yellow packet flow. Yellow packet flows may have excess
packets permitted through or dropped. Users may replace the DSCP field of these
packets by checking its radio button and entering a new DSCP value in the allotted field.
Counter – Use this parameter to enable or disable the packet counter for the specified
ACL entry in the yellow flow.
Violate – This field denotes the red packet flow. Red packet flows may have excess
packets permitted through or dropped. Users may replace the DSCP field of these
packets by checking its radio button and entering a new DSCP value in the allotted field.
Counter – Use this parameter to enable or disable the packet counter for the specified
ACL entry in the red flow.
Figure 8-47 ACL Flow Meter Display window
274
Advertisement
Table of Contents
