Snmp V6Host Table Settings - D-Link xstack DES-3810 series Reference Manual

®
xStack
The fields that can be configured are described below:
Parameter
Host IP Address
User-based Security
Model
Security Level
Community String /
SNMP V3 User Name
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

SNMP v6Host Table Settings

Users can set up SNMP trap recipients for IPv6.
To view the following window, click Management > SNMP Settings > SNMP v6Host Table Settings, as shown
below:
The fields that can be configured are described below:
Parameter
Host IPv6 Address
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 3-43 SNMP Host Table Settings window
Description
Type the IP address of the remote management station that will serve as the SNMP host
for the Switch.
SNMPv1 – Specifies that SNMP version 1 will be used.
SNMPv2 – Specifies that SNMP version 2 will be used.
SNMPv3 – Specifies that SNMP version 3 will be used.
NoAuthNoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
AuthNoPriv – To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
AuthPriv – To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
Figure 3-44 SNMPv6 Host Table Settings window
Description
Type the IPv6 address of the remote management station that will serve as the SNMP
host for the Switch.
51