Table of Contents
Advertisement
®
xStack
Adding an IPv4 ACL Profile
The window shown below is the Add ACL Profile window for IPv4. To use specific filtering masks in this ACL profile,
click on the packet filtering mask field to highlight it red. This will add more filed to the mask.
After clicking the Add ACL Profile button, the following page will appear:
The fields that can be configured are described below:
Parameter
Profile ID (1-1024)
Select ACL Type
802.1Q VLAN
IPv4 DSCP
IPv4 Source IP Mask
IPv4 Destination IP
Mask
Protocol
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 8-8 Adding ACL Profile window (IPv4 ACL)
Description
Here the user can enter a unique identifier number for this profile set. This value can be
set from 1 to 1024.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's
header.
Selecting this option instructs the Switch to examine the 802.1Q VLAN identifier of each
packet header and use this as the full or partial criterion for forwarding.
Selecting this option instructs the Switch to examine the DiffServ Code part of each
packet header and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address.
Enter an IP address mask for the destination IP address.
Selecting this option instructs the Switch to examine the protocol type value in each
frame's header. Then the user must specify what protocol(s) to include according to the
following guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol
(ICMP) field in each frame's header.
Select Type to further specify that the access profile will apply an ICMP type value, or
specify Code to further specify that the access profile will apply an ICMP code value.
Select IGMP to instruct the Switch to examine the Internet Group Management Protocol
(IGMP) field in each frame's header.
244
Advertisement
Table of Contents
