Ethernet Oam Settings - D-Link xstack DES-3810 series Reference Manual

®
xStack
The major features of Ethernet OAM are: OAM discovery, link monitoring, remote fault indication and remote
loopbacks.

Ethernet OAM Settings

This window is used to configure the ports Ethernet OAM mode. In Active mode the ports can initiate OAM discovery
and start or stop remote loopback. When a port in OAM enabled, any change to the OAM mode will cause the OAM
discovery to be restarted.
To view the following window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
Mode
State
Remote Loopback
Received Remote
Loopback
Click the Apply button to accept the changes made.
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 11-18 Ethernet OAM Settings window
Description
Specified a range of ports to be configured.
Specify to operate in either active mode or passive mode. The default mode is active.
Specify to enable or disable the OAM function. The default state is disabled.
If start is specified, it will request the peer to change to the remote loopback mode. If stop
is specified, it will request the peer to change to the normal operation mode.
Specify whether to process or to ignore the received Ethernet OAM remote loopback
command. The default method is ignore.
391