Table of Contents
Advertisement
®
xStack
Parameter
Port List
Authenticated
Authenticating
Blocked
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to remove entry based on the port list entered.
Click the View All Hosts button to display all the existing entries.
Click the Clear All Hosts button to remove all the entries listed.
JWAC Customize Page Language
Users can configure JWAC page and language settings for the Switch. The current firmware supports either English or
Japanese.
To view the following window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Customize
Page Language, as shown below:
To set the language used on the JWAC page, click the radio button for either English or Japanese.
Click the Apply button to accept the changes made.
JWAC Customize Page
Users can configure JWAC page settings for the Switch.
To view the following window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Customize
Page, as shown below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Description
Enter a port or range of ports.
Tick this check box to only clear authenticated client hosts.
Tick this check box to only clear client hosts in the authenticating process.
Tick this check box to only clear client hosts being temporarily blocked because of the
failure of authentication.
Figure 9-51 JWAC Customize Page Language window
324
Advertisement
Table of Contents
