Table of Contents
Advertisement
®
xStack
incoming packets whose PVID does not match the PVID of the port. Results can be seen in the table under the
configuration settings.
To view the following window, click L2 Features > VLAN > GVRP > GVRP Global Settings, as shown below:
The fields that can be configured are described below:
Parameter
GVRP State
Join Time (100-100000)
Leave Time (100-
100000)
Leave All Time (100-
100000)
NNI BPDU Address
Click the Apply button to accept the changes made for each individual section.
NOTE: The Leave Time value should be greater than twice the Join Time value. The Leave All Time value
should be greater than the Leave Time value.
GVRP Port Settings
On this page the user can configure the GVRP port parameters.
To view the following window, click L2 Features > VLAN > GVRP > GVRP Port Settings, as shown below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 5-10 GVRP Global Settings window
Description
Here the user can enable or disable the GVRP State.
Here the user can enter the Join Time value in milliseconds.
Here the user can enter the Leave Time value in milliseconds.
Here the user can enter the Leave All Time value in milliseconds.
Used to determine the BPDU protocol address for GVRP in service provide site. It can
use an 802.1d GVRP address, 802.1ad service provider GVRP address or a user defined
multicast address.
81
Advertisement
Table of Contents
