®
xStack
Host IP
Click the Edit button to re-configure the specific entry.
Click the Apply button to accept the changes made.
NOTE: To set the SSH User Authentication Mode parameters on the Switch, a User Account must be
previously configured.
Trusted Host Settings
Up to ten trusted host secure IP addresses or ranges may be configured and used for remote Switch management. It
should be noted that if one or more trusted hosts are enabled, the Switch will immediately accept remote instructions
from only the specified IP address or addresses. If you enable this feature, be sure to first enter the IP address of the
station you are currently using.
To view the following window, click Security > Trusted Host Settings, as shown below:
The fields that can be configured are described below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Mode field.
Enter the corresponding IP address of the SSH user. This parameter is only used in
conjunction with the Host Based choice in the Auth. Mode field.
Figure 9-85 Trusted Host Settings window
354