Table of Contents
Advertisement
®
xStack
Parameter
State
Replace Source IP
Remap Priority
Replace Priority
Untagged Member
Ports
Tagged Member Ports
Untagged Source Ports
Tagged Source Ports
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
After clicking the
Profile List
The fields that can be configured are described below:
Parameter
Profile Name
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
Click the
Show MLD Snooping Multicast VLAN Entries
IP Multicast VLAN Replication
IP Multicast VLAN Replication Global Settings
The window is used to configure the IP multicast VLAN replication parameters.
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Description
Here the user can enable or disable the state.
With the MLD snooping function, the MLD report packet sent by the host will be forwarded
to the source port. Before forwarding of the packet, the source IP address in the join
packet needs to be replaced by this IP address. If none is specified, the source IP
address will be replaced by "::".
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default setting is
None.
Specify that the packet's priority will be changed by the switch, based on the remap
priority. This flag will only take effect when the remap priority is set.
Specify the untagged member port of the multicast VLAN. Click the Select All button to
select all the ports or click the Clear All button to unselect all the ports.
Specify the tagged member port of the multicast VLAN. Click the Select All button to
select all the ports or click the Clear All button to unselect all the ports.
Specify the source port or range of source ports as untagged members of the multicast
VLAN. The PVID of the untagged source port is automatically changed to the multicast
VLAN. Source ports must be either tagged or untagged for any single multicast VLAN, i.e.
both types cannot be members of the same multicast VLAN
Specify the source port or range of source ports as tagged members of the multicast
VLAN.
link, the following page will appear:
Figure 5-89 MLD Snooping Multicast VLAN Group List Settings window
Description
Here the user can select the MLD Snooping Multicast VLAN Group Profile name.
link to view the MLD Snooping Multicast VLAN Settings.
139
Advertisement
Table of Contents
