Setting Default Values - Dräger Julian Instructions For Use Manual

Configuring in Standby Mode

Setting default values

Configuring in Standby Mode
The default settings for the monitoring functions and the
fresh gas and ventilation parameters can be configured in
standby mode. The default settings for the monitoring
functions and the choice of anaesthetic gas are valid
whenever the apparatus is switched on. The default
values for the alarm limits, fresh gas parameters and
ventilation parameters are valid after each standby.
Switch Julian to standby mode.
Press the softkey »config.«.
Display (example):
The following settings can be made in the menu:
– Default settings
– Calibration
– Anaesth. agent
Fields highlighted by a grey background contain the
currently valid settings.
z z z z
The symbol indicates a return to the previous
menu level.
Select, set and confirm the new settings with the
rotary knob.
Setting default values
Default values are valid whenever the apparatus is
switched on. The default monitoring settings can be
activated during operation with activate monitor
defaults, see "Activating monitor defaults" on page 71.
Select and confirm the default settings with the
rotary knob.
Display (example):
82
Standby / Configuration
anesth. agent calibration
selection O -sensor
2
auto man
21 vol.%
gas sensor
Isoflurane
more
The anesthetic
agent is automati-
cally selected by
gas identification
Standby / Configuration
anesth. agent calibration
selection
O -sensor
2
auto man
21 vol.%
gas sensor
Isoflurane
more
The anesthetic
agent is automati-
cally selected by
gas identification
default settings
pulse tone 0 1 2 3 4 5 6 7 8 9
alarm sound 1 2 3 4 5 6 7 8 9
scale adult child
parameters
record
interfaces
alarm limits
curves
basic configurations
IPPV default settings
PCV default settings
fresh gas delivery
default settings
These default settings are password
protected.
The default settings are active
on start-up.
To change the default settings
enter the password:
0 1 2 3 4 5 6 7 8 9
* * *
Turn and confirm .