Care List For Julian Anaesthetic Workstation - Dräger Julian Instructions For Use Manual

Care
Care list

Care list for Julian anaesthetic workstation

Only applies for non-infectious patients.
When used with infectious patients, all parts in contact with breathing gas must additionally be
sterilized after disinfection and cleaning.
What
Components which
can be conditioned
Julian workstation
Vapor 19.3 / Devapor unit
Power cable, compressed gas hoses,
equipotential bonding lead
Breathing bag with twin connector
and hose
Breathing hoses
Bellows
Y-piece
Cover of breathing system with
APL valve
Middle and bottom part of breathing
system
Container of bellows
Valve discs (use a cassette)
Expiration port
Absorber and insert
Water trap (monitoring)
Microbial filter 654 St
Filter of the measured gas
recirculation system
Flow sensor
AGS housing
AGS flow tube (without filter)
Container for AGS buffer volume
AGS transfer hose
Scavenging hose with connector
Waste gas connector with tube
Hose of sample gas return or hose of
sample gas scavenging
Emergency breathing bag, its
diaphragm, upper and lower valve
parts (Dräger Resutator 2000)
Silicone sleeve of secretion collecting
bottle and rinsing bottle, their lid with
float, suction hose and inspection
window
104
Conditioning intervals
Filter on
Y-piece
Front daily, other surfaces weekly
Daily
Daily
Weekly
Daily
Weekly
Weekly
Weekly
Weekly
Weekly
Weekly
Daily
–––
Weekly
Weekly
1) The conditioning intervals depend on the use and position of the filters. The table is
merely intended as a rough guide. The instructions of the hospital's hygiene officer shall
prevail!
How often
1)
Filter on inspiration
and expiration port
Daily
Monthly
Daily
Per patient
Weekly
Per patient
Weekly
Weekly
Weekly
Weekly
Weekly
Weekly
Daily
Daily
Weekly
Weekly
Weekly
Weekly
Weekly
Weekly
Monthly
Weekly
Weekly
After each use
As required,
but at least daily
Without filter
Per patient
Per patient
Daily
Per patient
Daily
Daily
Weekly
Daily
Daily
Daily
Daily
–––
Weekly
Daily