Alarms; Displaying And Setting Alarm Limits - Dräger Julian Instructions For Use Manual

Monitoring

Alarms

Alarms

Displaying and setting alarm limits

Alarms can be displayed and set from all three basic
screens (standard, data and trend screen) during
operation.
The default alarm limits for the ventilation mode are
activated automatically when changing from standby to a
ventilation mode.
These default alarm limits can be used unchanged or they
can be set individually for the patient.
The individual settings are deleted on changing from
ventilation mode to standby and the default alarm limits
are reactivated.
To call up alarm limits:
Press the softkey »alarm limits«.
Display (example):
The measured values and their alarm limits are shown on
the right-hand side.
The curves with the alarm limits represented by dashed
lines are shown on the left.
Example etCO :
2
The upper alarm limit (42 mmHg) and the lower alarm
limit (30 mmHg) are shown alongside the measured value
(38 mmHg).
A deactivated alarm limit is indicated by two dashes (– –).
To set an alarm limit:
Place the cursor bar on the alarm limit by turning the
rotary knob and press to confirm.
The alarm limit is highlighted.
Set the new value by turning the rotary knob and
press to confirm.
The new alarm limit is now effective. The cursor bar
z z z z
returns to the symbol.
60
IPPV
Pleth
CO
2
40
0
PAW
20
0
Adjust limit value: Turn and confirm !
Freshgas O + N O
2 2
P V
max
O % L/min mbar mL
2
50 1.00 25 600 10 1:2 10
38
etCO
2
alarm
98 --
SpO
95 limits
2
67
auto set
120
50
limits
38 42
alarm
etCO
30
2
info
--
6.0
MV
3.0
list
--
29
FiO
20
2
curves
0.8
1.0
FiHal.
0.0
config.
40
PAW
8
Freq. T :T T :T PEEP
T I E IP I
1/min % mbar
42
30
0