Setting The Illuminance - Dräger Polaris 600 Instructions For Use Manual

Operation
Restriction when a Polaris 600 light is
combined with Polaris 100/200 lights
The Polaris 100/200 light does not accept any
requests from a Polaris 600 light or the wall-
mounted control panel. The illuminance is always
set individually on the Polaris 100/200 light.

Setting the illuminance

Setting illuminance on the light control
panel and on the wall-mounted control
panel
The description of this function applies to both the
light control panel and the wall-mounted control
panel. Only the light control panel is shown in the
illustrations.
The light must be switched on before this function
can be activated, see "Switching the light on and
off" on page 48.
Reducing illuminance
 Press the key (A).
The illuminance is reduced.
If the key is kept pressed, the illuminance is
reduced continuously.
The change in the illuminance is shown by the
LED indicator (C).
50
C
A B
Increasing illuminance
 Press the key (B).
The illuminance is increased.
If the key is kept pressed, the illuminance is
increased continuously.
The change in the illuminance is shown by the
LED indicator (C).
– For further information on illuminance, see
"Technical light data" on page 92.
Instructions for use Polaris 600
C
A B