Commissioning The Tps 320I / 400I / 500I - Fronius TPS 320i Operating Instructions Manual

Commissioning the TPS 320i / 400i / 500i

Safety
General Commissioning the TPS 320i / 400i / 500i power sources is described by reference to a
manual gas-cooled MIG/MAG application.
Fitting the system The following diagram shows an overview of how the individual system components are
components put together.
(overview) For detailed information about the individual steps, please refer to the corresponding op-
erating instructions for the system components.
44
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
- the power source mains switch is in the "O" position
- the power source is unplugged from the mains