Table of Contents
Advertisement
OUT F
[List Mode]
Instruction
Step
5.3.4
OUT F
Annunciator output
5.3.4
OUT F
OUT F
: Number of the annunciator to be turned ON (bits)
D
Setting
Internal Devices
Data
Bit
Word
(Only F)
D
Function
(1) Operation results up to the OUT instruction are output to the designated annunciator.
(2) The following responses occur when an annunciator (F) is turned ON.
• The "USER"/"ERR." LED goes ON.
• The annunciator numbers which are ON (F numbers) are stored in special registers (SD64 to SD79).
• The value of SD63 is incremented by 1.
(3) If the value of SD63 is 16 (which happens when 16 annunciators are already ON), even if a new annunciator is turned
ON, its number will not be stored at SD64 to SD79.
(4) The following responses occur when the annunciator is turned OFF by the OUT instruction.
The coil goes OFF, but there are no changes in the status of the "USER" / "ERR." LED and the contents of the values
stored in SD63 to SD79.
Use the RST F
instruction to make the "USER"/"ERR." LED go OFF as well as to delete the annunciator which was
turned OFF by the OUT F
Operation Error
(1) There is no operation error in the OUT instruction.
Remark
1. For details of annunciators, refer to the User's Manual (Functions Explanation, Program Fundamentals) for the CPU
module used.
2. The number of basic steps for the OUT module F
3. The table below shows which CPU module features either the LED display device on front of the CPU module or "USER"
LED.
Type of LED
"USER" LED
"ERR." LED
146
Device
Command
J
\
R, ZR
Bit
Word
instruction from SD63 to SD79.
CPU Module Type Name
High Performance model QCPU, Process CPU,
Redundant CPU, Universal model QCPU, LCPU
Basic model QCPU
High
Basic
performance
F35
Zn
U
\G
––
instruction is 2.
Process
LCPU
Redundant Universal
Annunciator number
Constants
Other
Advertisement
Table of Contents
