Mitsubishi MELSEC-Q/L Programming Manual page 832

Example
• For timers T0 to T2, the program is created in the order the timer operates later.
T1
T0
X0
• For timers T0 to T2, the program is created in the order of timer operation.
X0
T0
T1
Appendix 2.1.5
Function
Designation method
Contact
Coil
Index modification
Set value
Present value
Update processing for present value
Contact ON/OFF processing
*1: The Q00J/Q00/Q01CPU can use Z0 to Z9.
The Universal model QCPU/LCPU can use Z0 to Z19.
Appendix 2.1.6
Instruction
*1
PR
*1
PRC
*1: Unusable for the Q00J/Q00/Q01CPU.
830
K1
T2
T2 timer starts measurement from the next scan after turning the contact of T1 ON.
K1
T1
T1 timer starts measurement from the next scan after turning the contact of T0 ON.
K1
T0
T0 timer starts measurement when X0 is turned ON.
K1
T0
T0 timer starts measurement when X0 is turned ON.
K1
T1
Contacts of T1 and T2 timers are turned ON when contact of T0 is turned ON.
K1
T2
Comparison of counters
QCPU/LCPU
• Enabled (only Z0 and Z1 are usable)
• Enabled (only Z0 and Z1 are usable)
• Disabled
• Enabled (Z0 to Z15 are usable)
• When OUT Cn instruction is executed
Comparison of display instructions
QCPU/LCPU
• When SM701 is OFF: Output continued until
00 encountered
H
• When SM701 is ON: 16 characters output
• When SM701 is OFF: 32-character comment
output
• When SM701 is ON: Upper 16 characters
output
AnUCPU
K100
C0
• Enabled
• Disabled
• Disabled
*1
• Enabled
• When END processing is done
AnUCPU
• When M9049 is OFF: Output continued until
00 encountered
H
• When M9049 is ON: 16 characters output
16-character comment output
AnACPU AnNCPU
K100
C0
• Disabled
• Disabled
• Disabled
• Enabled
AnACPU AnNCPU