Table of Contents
Advertisement
3.
AD57G MONITORING FUNCTIONS
MELSEC-A
3.9.1
Printing out collected
data a t
specified intervals (real-time report)
[Function]
This function outputs data to the printer so that the collected data can be
printed out in a specified format.
The function collects data and prints it out as shown below:
(Data collected using this function cannot be displayed on the screen.)
(1)
Data collection time
Once the AD57G starts monitoring, it will collect data for each data
collection trigger and print out the data even if a monitor screen is
displayed.
(2) Data collection and printout timing
Data is collected and printed out at a specified bit device leading
4
edgelfalling edge or at specified intervals.
However, if the printer is not connected, a time out occurs after the
operation starts.
(In the meantime, all other monitoring continues.)
The time out can be confirmed by using the AD57G systemlsystem alarm
screen (see Section 6.8).
(3)
Collected data print format
When the collected data is printed out, the operation is executed accord-
ing to the type of report.
I
When a real-time report consisting of several pages is selected (see
Section 3.9 (8)(a) and (b)):
Continues printing out the data collected from the devices specified as
report canvas screens.
When a real-time report consisting of one page is selected (see
Section 3.9 (8)(c)):
4
Repeat the steps in which the data is collected from the devices
specified as report canvas screens and one report per page.
However, if the PC
CPU i s
not equipped with a clock function,
"00"
appears in the place where the time would be printed out.
Advertisement
Table of Contents
