Table of Contents
Advertisement
PLF
(1) Turns ON the designated device when the execution command is turned ON
other case the execution command is turned ON
command).
When there is one PLF instruction for the device designated by
scan.
See Page 115, Section 3.9 for the operation to be performed when the PLF instruction for the same device is executed
more than once during one scan.
X5
PLF
(2) If the RUN/STOP key switch is changed from RUN to STOP after the execution of the PLF instruction, the PLF
instruction will not be executed again even if the switch is set back to RUN.
Note that the device designated by
the CJ instruction or if the executed subroutine program was not called by the CALL instruction.
Operation Error
(1) There is no operation error in the PLS or PLF instruction.
Program Example
(1) The following program executes the PLS instruction when X9 goes ON.
[Ladder Mode]
[Timing Chart]
ON
X9 OFF
ON
M9 OFF
1 scan
(2) The following program executes the PLF instruction when X9 goes OFF.
[Ladder Mode]
OFF (i.e., at OFF
X5 OFF
M0
M0 OFF
may remain ON for more than one scan if the PLS or PLF instruction is jumped by
D
[List Mode]
Step
[List Mode]
Step
OFF, and turns OFF the device in any
OFF, OFF
ON or ON
during one scan, the specified device turns ON one
D
ON
ON
1 scan
1 scan
Instruction
Device
Instruction
Device
PLS, PLF
1
ON of the execution
2
3
4
5
6
7
8
153
Advertisement
Table of Contents
