Mitsubishi MELSEC-Q/L Programming Manual page 563

(2) If the value does not result in an integer, this instruction rounds the value to the whole number.
(3) Set the X coordinate of the scaling conversion data in ascending order.
(4) Set the input value within the range of the scaling conversion data (within the range of
S1
(5) If some specified points have same X coordinates, the Y coordinate data of the highest point number will be output.
(6) Specify the number of coordinate points of scaling conversion data from 1 to 32767.
DSCL(P)
(1) This instruction executes scaling for the scaling conversion data (32-bit data units) specified by
specified , and then stores the operation result into the devices specified by
S1
The scaling conversion is executed based on the scaling conversion data stored in the device specified by
Scaling conversion data component
Setting item Device assignment
Number of coordinate points S2 , S2
+1
X coordinate S2 , S2
+3 +2
Point 1
Y coordinate S2 , S2
+5 +4
X coordinate S2 S2
,
+7 +6
Point 2
S2 S2
Y coordinate ,
+9 +8
X coordinate
S2 , S2
+4n 1 +4n 2
Point n
S2 , S2
Y coordinate
+4n+1 +4n
n indicates the number of coordinates
specified by (S2).
(2) If the value does not result in an integer, this instruction rounds the value to the whole number.
(3) Set the X coordinate of the scaling conversion data in ascending order.
(4) Set the input value within the range of the scaling conversion data (within the range of
S1
(5) If some specified points have same X coordinates, the Y coordinate data of the highest point number will be output.
(6) Specify the number of coordinate points of scaling conversion data from 1 to 32767.
Y
Operation
Operable range
error
Output D
value
Point 1
Point 2
SCL, SCLP, DSCL, DSCLP
.
D
Operation error
Input value S1
X
Point n 1
Point n
devices).
S2
with the input value
S2
and up.
S2
and +1 devices).
S2 S2
561
1
2
3
4
4
6
7
8