Mitsubishi MELSEC-Q/L Programming Manual page 625

Function
(1) This instruction reads the module information stored in the area starting from the I/O number specified by "n", and stores
it in the area starting from the device specified by
The following 6 modules (Q series only) support the instruction.
• CPU module
• Input module
• Output module
• I/O combined module
• Intelligent function module
• GOT (bus connection)
For the LCPU, the following four models are supported.
• CPU module
• Input module
• Output module
• Intelligent function module
(2) The value of n is specified by the first 3 digits of the hexadecimal 4 digits that represent the start I/O number of a module
whose model name is to be read.
• When the target module occupies one slot
Universal model QCPU
Power
CPU
supply QX10 QX10 QX10 QX10
module
module
3E00 0000 0010
H H
Specify H3E0 as the start I/O number of the CPU slot.
LCPU
CPU module
(L26CPU-BT)
Power
Built-in Built-in
supply CPU
I/0 CC-Link
module
0000 0010
H
Specify H3E0 to read the module name of the CPU module.
1. On the LCPU, if the built-in I/O or first I/O on the built-in CC-Link is specified, then the model name of the CPU module is
read.
D
Q68 QY41
QY10 QY10
ADV P
0020 0030 0040 0050 0070
H H H H H
Specify K3 or H3 as the start I/O number to be read.
LX40 LX40 LX40 L60A LY41
C6 C6 C6 D4 NT1P
0030 0040 0050 0060 0070
H H H H H
.
0080 Start I/O number configured in
H H
the I/O assignment setting
LY10 LY10 LY10
R2 R2 R2
0090 00A0 00B0
H H H H
Specify K6 or H6 as the start I/O number to be read.
TYPERD, TYPERDP
Start I/O number configured in
the I/O assignment setting
1
2
3
4
4
6
7
8
623