Mitsubishi MELSEC-Q/L Programming Manual page 643

(3) Be sure to use word units to designate the number of request read data (
reading result (No. of read data) (
The following shows how the data is read in binary data reading operation.
Total
Read
data
(4) When reading binary data
(a) If the extension of the target file is omitted, ".BIN" is used as an extension.
(b) When the designated file does not exist, an error occurs.
(c) If the position specified is greater than the existing file size:
• The High Performance model QCPU of which the first 5 digits of the serial number are "01111" or lower results in
an error.
• The High Performance model QCPU/Process CPU/Redundant CPU/Universal model QCPU/LCPU of which the
first 5 digits of the serial number are '01112' or higher will perform reading at point 0 and will be completed
normally.
(5) When reading data after CSV format conversion
(a) The elements in CSV format file (cells for EXCEL) are read by each row. The numerical value and character strings
are converted into binary data and stored in the device.
(b) If the extension is omitted, ".CSV" is used as an extension.
(c) When the designated file does not exist, an error occurs.
(d) The data designated by the number of request read data (
When the last data of the file is reached before the specified number of data are read:
• The High Performance model QCPU of which the first 5 digits of the serial number are "01111" or lower results in
an error.
• The High Performance model QCPU/Process CPU/Redundant CPU/Universal model QCPU/LCPU whose the
first 5 digits of the serial number are '01112' or higher reads the data up to the point where the reading is
possible.
).
D1
Control data
D0 +0 H0000 Execution/completion type
+1 - (Not used)
D0
+2 K3
D0 No. of request read data
-
D0 +3 (Not used)
K1
+4
D0
+5
D0 Location to start reading in the file
D0 +6 K0 No. of columns designation
+7 K0 Data type specification
D0
Data device File data (in byte units)
D1 +0 K3
+1 H33 22
D1
+2 H55 44
D1
D1 +3 H77 66
+2), file position (
D0
H00
H11
H22
H33
H44
H55
H66
H77
H88
H99
HAA
+2) are read from the beginning of the file.
D0
SP.FREAD
+4 and +5), and
D0 D0
641
1
2
3
4
4
6
7
8