Enter Calibration And Setup; Enter Calibration And Setup Setup Menu #1 - Cardinal 225 Installation And Technical Manual

With the indicator ON, press the SHIFT key and then press the Navigation ENTER key (red
square key in center of the Navigation arrows). The display will change to show the
SETUP/REVIEW MENU.

1.ENTER CALIBRATION AND SETUP

2.VIEW AUDIT TRAIL COUNTERS
3.CALIBRATE SCALE 1
Enter Selection: 1
1. ENTER CALIBRATION AND SETUP
SETUP MENU #1
With the SETUP/REVIEW MENU displayed, press the 1 key and then the ENTER key. The
display will change to show SETUP MENU #1.
1. USA=XXX
2. NSC=XXX
3. LFT=XXX
4. N/A
5. TIME=XX
Enter Selection:
1. USA=XXX (DOMESTIC or INTERNATIONAL)
With SETUP MENU #1 displayed the current setting for the USA= parameter will be shown.
Note that XXX is the current value. If the setting displayed is acceptable, proceed to the
next setup parameter.
Otherwise, press the 1 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
USA=YES (Domestic)
DATE = MM/DD/YY
Z LIMIT = NO
CAP + 5% to OC
CALIBRATION AND SETUP, CONT.
SETUP/REVIEW MENU
SETUP MENU #1
8200-M698-O1 Rev B  225 Installation and Technical
8.SCALE ID=00
9.DEL CUSTOM TICKET
10.PRINT SETUP
^ EXIT
6. CLR TARE=XXX
7. CLEAR ID=XXX
8. NO OF SCALES=X
9. TOTALIZE=XXX
10. MODE OF OP=0
0 ` NEXT ^ EXIT
USA=NO (International)
DATE = DD/MM/YY
Z LIMIT = YES
CAP + 9 grads to OC
ETR able = YES
PT printed with tare. Lamp test on
power up. Lorry Weigher Operation
(Any MODE OF OP but 1 or 6).
NSC (Australia NSC Requirements)
setup parameter selection allowed
NORM
45