Preset Weight Comparators Operation - Cardinal 225 Installation And Technical Manual

PRESET WEIGHT COMPARATORS OPERATION

The Model 225 indicator has sixteen (16) outputs, which can be configured during the setup of
the weight indicator to perform as Preset Weight Comparators "PWC". If the PWC feature was
selected during setup, the indicator will compare each enabled preset weight value with the
displayed weight and then output a signal for each preset based on the comparison results.
Enter Preset Values
With the indicator in normal operations mode, press the PRESET key.
1.P=XXXXXX
2.P=XXXXXX
3.P=XXXXXX
4.P=XXXXXX
5.P=XXXXXX
6.P=XXXXXX
ENTER PWC# TO CHANGE: 0
PRESET
1. P=XXXXXX (PRESET 1 WEIGHT VALUE)
through
16. P=XXXXXX (PRESET 16 WEIGHT VALUE)
1. The display will change to show the values for the enabled PWCs. Note that XXXXXX
is the current value for each preset.
NOTE: In the example shown above, all 16 preset values are shown enabled.
2. If the values displayed for each preset are acceptable, press the ENTER key to exit and
return to normal operation.
3. Otherwise, to change a preset weight value, use the numeric keys to select the PWC#
(1 to 16) to change and then press the ENTER key. The display will change to show
the current value (PWC #= XXXXXX) of the preset selected.
4. Using the numeric keys, enter the new value for the preset and then press the ENTER
key to save the new setting.
5. Continue with this procedure until a value for each preset to be used has been entered.
6. After the last preset value has been entered, press the TRIM soft key to enter the preset
trim weight values or press the ENTER key to exit and return to normal operation.
NOTE: Enter a zero (0) then press the ENTER key if the preset weight comparator is
not to be used.
110
7.P=XXXXXX
8.P=XXXXXX
9.P=XXXXXX
10.P=XXXXXX
11.P=XXXXXX
12.P=XXXXXX
TRIM
8200-M698-O1 Rev B  225 Installation and Technical
13.P=XXXXXX
14.P=XXXXXX
15.P=XXXXXX
16.P=XXXXXX
17. SET TRIM
18. SET SCALE
SCALE EXIT