Setup And Calibration - Cardinal 204 Installation And Technical Manual

Hide thumbs Also See for 204:

Operation manual (22 pages)

Table Of Contents

Table of Contents

Your 204 indicator has been thoroughly tested and calibrated before being shipped to you. If

you receive the indicator with a scale, calibration is not necessary. If the indicator is being

connected to a scale for the first time or recalibration is necessary for other reasons, proceed

as indicated.

Calibration of the 204 indicator is accomplished

entirely by the keypad. To enter the setup and

calibration mode:

1. With the power off, remove the Calibration

Access Screw on the upper left corner of the

rear panel, see Figure No.8.

2. With the screw removed, insert a small non-

metallic tool into the screw hole and press

and hold the calibration switch.

3. Press the ON/OFF key.

4. The display will show int=. The indicator is

now ready for setup and calibration.

During the setup and calibration process it will be necessary to enter operational

parameters via the 204's keyboard. Pressing the PRINT key will cause the data entered

or displayed to be retained and the 204 will advance to the next prompt. The cursor

location is identified by the blinking character and can be advanced to the left to the next

position by pressing the ASTERISK key. Pressing the UNITS key will change the

blinking character to the next value.

int= (Scale Interval)

With the display showing int= press the ASTERISK key to show the current setting. Press

the UNITS key until the proper scale interval (1, 2, 5, 10 or 20) is displayed and then press the

PRINT key to store the displayed value and proceed to the next prompt.

Flash= (Flash)

To display FLASH, press the calibration switch while the display is showing the prompt

int= (Scale Interval). With the display showing FLASh=, press the PRINT key. The

display will change to show 0 (0=NO). Press the PRINT key to proceed to the next prompt

Unit= (Weighing Units). To return to the int= prompt, start the setup and calibration

process over.

THE FLASH UPDATE OPTION IS AVAILABLE IN THE 204 INDICATOR AND IN

NCONTROL WITH REV 2.0 OR GREATER.

Unit= (Weighing Units)

With the display showing Unit= press the UNITS key to show the current setting. If the value

shown is acceptable, press the PRINT key again to save it, otherwise press the UNITS key to

enter the new weighing units and press the PRINT key to save the new setting.

0 = None

1 = Pounds Only

2 = Kilograms Only

8555-M313-O1 Rev H • 204 Installation & Technical