Badge Reader - Cardinal 225 Installation And Technical Manual

BADGE READER

5. BADGE RDR (BADGE READER)
The badge reader setup parameter determines the port used by the badge reader, the type
of badge reader used and the weight needed on the scale (threshold weight) before the
badge reader will work.
With the SETUP MENU #3 displayed press the 5 key and then the ENTER key. The display
will change to show the BADGE READER SETUP Menu.
1. PORT=2
2. TYPE=1
3. THRES WT = 1500
4. SITE ID = XXX (Only displayed if Type=1, AWID)
Enter Selection: 0
1. Port= (BADGE READER PORT)
With the BADGE READER SETUP Menu displayed the current setting for the Port=
parameter will be shown. This is the serial port the indicator will use for the Badge
Reader. If the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 1 key, the ENTER key and then using the numeric keys, enter the
value for the serial port the indicator will use for the Badge Reader and then press the
ENTER key to save the new setting and return to the BADGE READER SETUP Menu.
Allowable values are 1, 2 or 3.
1 = COM1
2. TYPE=X XXXXXXXXXX (TYPE OF BADGE READER)
With the BADGE READER SETUP Menu displayed the current setting for the TYPE=
parameter will be shown. Note that X is the current value and XXXXXXXXXX is the
description. If the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 2 key, the ENTER key and then using the numeric keys, enter the
value for the type of badge reader and then press the ENTER key to save the new
setting and return to the BADGE READER SETUP Menu. Allowable values are 0
through 5.
0 = NONE
1 = AWID (See Note)
NOTE: If you selected 1 = AWID for the TYPE= parameter, the setup parameter
4. SITE ID= will be shown on the BADGE READER SETUP Menu.
88
CALIBRATION AND SETUP, CONT.
BADGE READER SETUP Menu
COM2
AWID
2 = COM2
2 = SMARTPASS
3 = HID
8200-M698-O1 Rev B  225 Installation and Technical
^ EXIT
3=COM3
4 = MAGS (MAGSTRIP)
5 = FLEXPASS