Password; 2Xx- (2Xx Option Card) - Cardinal 225 Installation And Technical Manual

Using the numeric keys, enter the value for the new backlight turn-on level and then press
the ENTER key to save the new setting and return to SETUP MENU #3. Allowable values
are 0 through 99.
NOTE: The value selected must be less than the Lights= value to activate.
BACK LITE=0
Backlight always ON

PASSWORD

3. PASSWORD (PASSWORD)
The password setup parameter determines whether a password is required to enter
Calibration and Setup on indicators programmed for international use (USA=NO). If the
indicator is programmed for domestic use (USA=YES) the password parameter WILL NOT
be displayed on SETUP MENU #3.
With the SETUP MENU #3 displayed press the 3 key and then the ENTER key. The display
will change to show PASSWORD=XXXXXXXXXXXX. Note that XXXXXXXXXXXX is the
current password if a password was previously entered, otherwise only PASSWORD= will
be displayed.
If the setting displayed is acceptable, proceed to the next setup parameter. Otherwise,
using the alphanumeric keys, enter up to 12 characters for the password and then press the
ENTER key to save the new setting and return to the SETUP MENU #3.
With a PASSWORD set, anytime the operator tries to enter Calibration and Setup, the
display will show the PASSWORD= prompt requiring the operator to enter the correct
password. If the wrong password is entered, the indicator displays ERROR momentarily and
returns to the weight mode. Note that the password is not shown on the display when the
operator is entering it.
NOTE: It is recommended to write the password down and store it in a secure
location. If the password is forgotten or lost and a change to the indicator setup is
required, the indicator must be reprogrammed. WARNING! Reprogramming the
indicator will ERASE ALL the contents of the Nov-Ram and memory.
2XX– OPTION CARDS

4. 2XX- (2XX OPTION CARD)

This prompt will ONLY be displayed when a 2XX Option Card is installed in the indicator.
Refer to the manual for the 2XX option card installed for setup instructions.
CALIBRATION AND SETUP, CONT.
BACK LITE=99
Backlight always OFF
PASSWORD OPERATION
8200-M698-O1 Rev B  225 Installation and Technical
BACK LITE=XX
Level that backlight
turns ON at
87