Local Remote Port - Cardinal 225 Installation And Technical Manual

LOCAL REMOTE PORT

NOTE: Although shown on this example of SETUP MENU #3, the setup
parameter LRPort= will only be displayed when TYPE=SERIAL has been
selected in SCALE 1 SETUP MENU #1.
1. G/N ACCUMS=XXX
2. BACK LITE= X
3. PASSWORD
4. 2XX-
5. BADGE RDR
Enter Selection: 0
7. LRPort= (LOCAL REMOTE PORT)
With the SETUP MENU #3 displayed the current setting for the LRPort= parameter
will be shown. This is the serial port the indicator will use for the Local/Remote
connection. Note that COM3 is the current port shown. This is the system default port.
If the setting displayed is acceptable, press EXIT (Navigation Keys  Down Arrow) to
return to the SETUP/REVIEW MENU.
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
value for the serial port the indicator will use for the Local/Remote port and then press
the ENTER key to save the new setting and return to the SETUP MENU #3. Allowable
values are 1, 2 or 3. NOTE: 3=COM3 is the default setting.
LR Port=3
With the SETUP MENU #3 displayed,
 Press PREV (Navigation Keys  UP Arrow) to return to SETUP MENU #2.
 Press EXIT (Navigation Keys  Down Arrow) to return to the SETUP/REVIEW MENU.
CALIBRATION AND SETUP, CONT.
SETUP MENU #3
SETUP MENU #3
Select Local-Remote Port
1=COM1
8200-M698-O1 Rev B  225 Installation and Technical
6. KEY LOCKOUT
7. LRPort=COM3
^ PREV ` EXIT
2=COM2 3=COM3
91