D-Link DES-3028 Cli Reference Manual page 22

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
enable telnet
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
DES-3028P:4#disable telnet
Command: disable telnet
Success.
DES-3028P:4#
telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
enable telnet <tcp_port_number 1-65535>
This command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP or UDP port number the Switch will
use to listen for Telnet requests.
<tcp_port_number 1-65535>  The TCP port number. TCP ports
are numbered between 1 and 65535. The "well-known" TCP port for
the Telnet protocol is 23.
Only Administrator-level users can issue this command.
DES-3028P:4#enable telnet 23
Command: enable telnet 23
Success.
DES-3028P:4#
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the Switch.
None.
Only Administrator-level users can issue this command.
Used to Telnet another device on the network.
telnet <ipaddr> {tcp_port <value 0-65535>}
This command is used to connect to another device's management
through Telnet.
<ipaddr>  Enter the IP address of the device to connect through,
using Telnet.
tcp_port <value 0-65535>  Enter the TCP port number used to
connect through. The common TCP port number for telnet is 23.
Only Administrator-level users can issue this command.
17