D-Link DES-3028 Cli Reference Manual page 123

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config vlan vlanid
Syntax
Description
Parameters
Restrictions
Example usage:
To config vlan vlanid on the switch:
DES-3028P:4#config
advertisement enable name RG
Command: config vlan vlanid 5 add tagged 7 advertisement
enable name RG
Success.
DES-3028P:4#
config gvrp
Purpose
Syntax
Description
Parameters
config vlan vlanid <vidlist> {add [ tagged | untagged | forbidden
] | delete <portlist> | advertisement [enable | disable] | name
<name>}
The config vlan vlanid command allows you to add or delete ports of
the port list of previously configured VLAN(s). You can specify the
additional ports as being tagged, untagged or forbidden. The same
port is allowed to be an untagged member port of multiple VLAN's.
You can also specify if the ports will join GVRP or not with the
advertisement parameter. The name parameter allows you to specify
the name of the VLAN that needs to be modified.
<vidlist>  Specifies a range of multiple VLAN IDs to be configured.
tagged  Specifies the additional ports as tagged.
untagged  Specifies the additional ports as untagged.
forbidden  Specifies the additional ports as forbidden.
<portlist>  A range of ports to add to the VLAN.
advertisement  Entering the advertisement parameter specifies if
the port should join GVRP or not. There are two parameters:
enable  Specifies that the port should join GVRP.

Disable  Specifies that the port should not join

GVRP.
name  Entering the name parameter specifies the name of the
VLAN to be modified.
<name>  Enter a name for the VLAN
Only Administrator-level users can issue this command.
vlan vlanid
Used to configure GVRP on the Switch.
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
This command is used to configure the Group VLAN Registration
Protocol on the Switch. Ingress checking, the sending and receiving
of GVRP information, and the Port VLAN ID (PVID) can be
configured.
<portlist>  A port or range of ports for which users want to enable
GVRP for.
all  Specifies all of the ports on the Switch.
state [enable | disable]  Enables or disables GVRP for the ports
specified in the port list.
118
5 add tagged 7